Bostik's Ultimate Adhesive Remover Towels are readily biodegradable, low odor, water clean-up solution. Use Bostik's Ultimate Adhesive Remover to remove wet and cured urethane adhesive from the surface of pre-finished (non-wax) wood flooring. 

Contains 60 Towels

Directions for Use:
1) Open lid and pull out towels.
2) Rub area of the floor that has cured or wet adhesive using a pre-soaked towel.
3) If adhesive has cured for more than 2 days, lay a towel over cured adhesive and let it stand for approximately 5 minutes. Wipe area clean with a fresh towel. Note: Do not allow excess remover to drip between floor boards.
4) Wipe entire area cleane with Ultimate Urethane Remover using a clean, water-dampened cloth.

Flammability:
Ultimate Urethane Remover is non-flammable.

Warning:
This product contains the following chemicals which are reportable under Federal OSHA Hazard Communication Standard, and NJ and PA Right to Know regulations: Dimethyl Adipate (627-93-0); Dimethyl Glutarate (1119-40-0)
May cause eye, skin and respiratory tract irritation.

Precaution:
Avoid contact with eyes, skin and clothing. Wear protective clothing when handling. Use with adequate ventilation.

California Prop 65 listed chemicals: None.
Refer to Material Safty Data Sheet for all hazardous information pertaining to this product.

Keep Out of Reach of Children.
In case of emergency, call 1-800-227-0332
Bostik: 978-777-0100